The putty of the walls is one of the most important tasks associated with the interior decoration. This is an activity that not only a construction specialist can cope with, but the use of his services is necessary if we decide to use the filler spray. This method of applying plaster is more difficult, since it requires knowledge of equipment and the ability to choose the right product. Why is it worth deciding on such putty and what errors should be avoided when performing it? Applying the plaster with spraying - why should you choose such services?
The plaster can be applied to the walls both manually and mechanically. It should be emphasized that both of these methods give good results, although the application of gypsum mechanically gives more benefit. Time is the greatest of them. The putty is performed much faster with spraying, due to which finishing work takes less time. It is also worth noting that this method increases the efficiency of work. The method of spraying putty also saves material. Compared to manual application of plaster, saving can be up to 30%. A great advantage of mechanical putty is that the plaster is evenly distributed over the entire surface. However, you need to remember the use of gypsum designed for this method. Can you use any plaster when plastering with spraying?
As mentioned earlier, not all materials can be used to apply the finish coating with spraying. The finish applied by a gun cannot be random, so it is best for this task to be taken by specialists in finishing work. For each unit, special products should be used. Information about how they can be can be found in information from the manufacturer, which is usually located on a technical sheet. The mixtures designed for machine application are available in the form of dry finishing coatings and ready -made mixtures. It should be emphasized that the coatings intended for manual application are not suitable for machine plaster, while most of the sprayed plasters can be applied manually. The most common errors when spraying the plaster layer
In addition to buying inappropriate plaster, another mistake may be the use of inappropriate plastering unit and the wrong choice of pressure during operation. The best results are given by the use of a hydrodynamic installation with a piston pump. Good aggregates also have a pressure regulation function. Errors when spraying the finish coating can also be associated with improper selection of the nozzle diameter, as well as the improper choice of the mixer. Further problems can be caused by an incorrect consistency of plaster, as well as incorrectly applying it to the surface. It should be noted that errors made when applying the finish coating with spraying can be expensive, so they should be entrusted to specialists. Do you want to move to Australia? Find Immigration solicitor in Parramatta Sydney. Immigration lawyers will have you with documents.